Sailing Yabá · video

Hva denne videoen dekker

The crew of the boat Yaba prepares for a haul-out at a shipyard by fabricating new gaff-rig components, specifically the boom, gaffs, and mast jaws.0:18 To ensure the jaws remain horizontal when the gaff is raised to a 45-degree angle, the owner extends the jaw horns upward using a custom joint.4:10 This joint features a mortise-and-tenon design secured with epoxy and a wooden tree nail, or peg, which is driven through an offset hole to pull the joint tight.10:05 The team uses scrap ash and ipir wood sourced from the shipyard to construct these parts.8:17 To protect the raw wood from moisture and warping, they apply varnish immediately after sanding.23:57 The project is completed under a strict deadline as the boat awaits its turn in the shipyard’s launch crib.14:09 The crew also applies animal fat to the shipyard’s wooden slipway planks to reduce friction during the boat’s transition into the water.22:56

Mer fra Sailing Yabá

This Anchorage Was Worth Every Miserable Mile — Sailing Yabáaug. 2026Sailing Fully Rigged at Night After Emergency Repairs — Sailing Yabáaug. 2026Sailing Through the World's Largest Atlantic Rainforest! — Sailing Yabájuli 2026Sailing to Brazil's Most Dangerous Sandbanks — Sailing Yabájuli 2026

Fra Sailing Yabá – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.