Sailing Some Tuesdayvídeo
Starlink on Boats: What Cruisers Need to Know (Gen3 Setup, Plans, Tips) CRITICAL UPDATE - SEE BELOW
21 de abril de 2026 · 15 min · 9K visualizações · middle of the Pacific Ocean
Crew holds Starlink Mini and original dish for backup
O que este vídeo aborda
Steve Dunlap aboard Some Tuesday, mid-Pacific at roughly 117°W, 5°S en route to Nuku Hiva, delivers a Starlink setup guide built from 20 hours of troubleshooting at sea.▶ 0:00 On hardware: buy the Gen 3 standard dish at $350, mount it flat, and ignore the app's alignment warnings — Some Tuesday pulls 150 Mbps that way.▶ 1:04 Skip the Gen 2 motorized dish (known problems on boats) and the marine high-performance dish (nearly six Gen 3 units for the same price).▶ 1:04 On plans: the Roam Unlimited plan at $165/month is the pick; it enables Ocean Mode at $2/gigabyte, which activates in about 15 minutes and provides unlimited data within 12 miles of land.▶ 2:49 Critical: Ocean Mode does not turn off automatically when you return within 12 miles — forgetting this cost Dunlap $500 at a dock in El Salvador and cost another cruiser nearly $2,000.▶ 4:21 On redundancy: carry a Starlink Mini as a backup on the same service line (no extra monthly fee); activate it as a standalone device, not a mesh node, so it works independently if the primary dish fails.▶ 8:49 A third, unactivated Gen 3 sits in storage — firmware-updated every few months but not billed.▶ 9:48 On power: Starlink's own 12-volt DC power supply caused constant reboots and satellite-link failures after a $600 installation.▶ 13:35 Reverting to the stock AC power supply fixed everything immediately.▶ 13:56 The 12V supply's unreliability is a known forum issue; use AC.
Barcos neste vídeo
Mais de Sailing Some Tuesday
De Sailing Some Tuesday — veja o barco, a tripulação e cada vídeo analisado do canal.