Another Adventure · vídeo

O que este vídeo aborda

A cored-hull sailboat named Tridium undergoes below-waterline through-hull installation while afloat, a procedure the crew argues is straightforward when executed correctly.0:16 Cored hulls require prep work before drilling: remove the inner laminate layer and all coring material, leaving the outer laminate intact, then bond the two layers together to seal the coring.1:04 The through-hull fitting must be threaded to accept a backing nut and gate valve, and its inner surface gets a thick bead of 3M 5200 or 4000 applied 15–20 minutes before submersion to allow partial air cure.1:46 Stuffing foam inside the fitting prevents water flowing freely through it during installation.2:15 The sequence runs: drill a quarter-inch pilot hole first, have the diver locate it from outside and sand the hull surface, then use a plunger or bowl to limit flow while the full hole-saw cut is made.2:58 A bung or palm covers the finished hole until the diver pushes the pre-coated through-hull inward, a second bead of 5200 goes on the inside flange, and the backing nut and ball valve are torqued down while the diver holds the fitting against spinning.3:39 Done correctly, the diver brings more water into the boat on their body than enters through the installation process.0:25

Mais de Another Adventure

literally BULLETPROOF nav lights at ShowMeYourDinghy comago. de 2026Tritium Panama Canal Crossingabr. de 2026Show Me Your Dinghy! The MOST waterproof and affordable Dinghy Navigation light available!jul. de 2025Clark pump deconstruction comparing Spectra vs Solarmaax watermakers with money saving secretsmai. de 2025

De Another Adventure — veja o barco, a tripulação e cada vídeo analisado do canal.

The Sailing Directory Newsletter

Um e-mail com os melhores achados da frota — os momentos, barcos e histórias que valem o seu tempo de visualização. Insira seu endereço para receber sua própria cópia.