kentblairlvídeo
Nutshell Pram Tiller Repair II
7 de junho de 2026 · 3 min · 79 visualizações
O que este vídeo aborda
A wooden tiller bushing on a Nutshell Pram rudder assembly failed — the original dowel piece had dried out, cracked, and had already been glued and taped once without lasting success.0:20 Kent sourced the same dowel stock used originally, drilled a half-inch hole into its end, and cut a new bushing, sizing it deep enough to potentially yield two pieces.0:59 He coated the new bushing inside and out with Dixo thickened epoxy to stabilize the dry wood and seal it against moisture, planning to re-drill the center hole with a quarter-inch bit once the epoxy cures, leaving a thin epoxy lining to block water intrusion.1:16 The bushing fits over a machine screw with washers and a nylon lock nut, and the notched end seats into the rudder cheek.0:02 After installation, Kent plans to wrap the outside with gaff tape for cushioning and additional protection.2:42 Saturating dry, brittle wooden hardware with thickened epoxy before final drilling preserves the wood and seals the bore without requiring a replacement part.
Mais de kentblairl
De kentblairl — veja o barco, a tripulação e todos os vídeos analisados do canal.
The Sailing Directory Newsletter
Um email com os melhores achados da frota — os momentos, barcos e histórias que valem o seu tempo de visualização. Insira o seu endereço para receber a sua cópia.