kentblairlvideo
Nutshell Pram Tiller Repair II
7 de junio de 2026 · 3 min · 87 vistas
¿Qué cubre este video?
A wooden tiller bushing on a Nutshell Pram rudder assembly failed — the original dowel piece had dried out, cracked, and had already been glued and taped once without lasting success.0:20 Kent sourced the same dowel stock used originally, drilled a half-inch hole into its end, and cut a new bushing, sizing it deep enough to potentially yield two pieces.0:59 He coated the new bushing inside and out with Dixo thickened epoxy to stabilize the dry wood and seal it against moisture, planning to re-drill the center hole with a quarter-inch bit once the epoxy cures, leaving a thin epoxy lining to block water intrusion.1:16 The bushing fits over a machine screw with washers and a nylon lock nut, and the notched end seats into the rudder cheek.0:02 After installation, Kent plans to wrap the outside with gaff tape for cushioning and additional protection.2:42 Saturating dry, brittle wooden hardware with thickened epoxy before final drilling preserves the wood and seals the bore without requiring a replacement part.
Más de kentblairl
De kentblairl — ve el barco, la tripulación y cada video analizado del canal.
The Sailing Directory Newsletter
Un correo electrónico con los mejores hallazgos de la flota: los momentos, barcos e historias que valen tu tiempo de visualización. Ingresa tu propia dirección para obtener tu propia copia.