BoatworksToday · βίντεο

Τι καλύπτει αυτό το βίντεο

Repairing fiberglass hull damage from only one side requires a significantly wider taper than a standard two-sided repair to ensure structural integrity. When access to the interior is blocked by molded liners or foam, grind the damaged area back to a clean edge and create a taper ratio of 18:1 or 24:1, rather than the conventional 12:1. For a hull approximately 1/8-inch thick, extend the taper at least four inches beyond the damage perimeter.7:38 Use 1708 biaxial fabric for structural strength and 1.5-ounce chop strand mat for surface stabilization and cosmetic finishing.8:12 Laminating polyester resin allows for subsequent layers of polyester-based fairing compound or gel coat to bond without additional sanding, provided the resin remains in its tacky state.14:14 After laying the glass, fill low spots with a fiber-reinforced structural putty, then apply a wax-additive gel coat or PVA to ensure a full cure.14:08 Final fairing requires sanding the perimeter first to blend the edges before addressing the center.17:46

Περισσότερα από το BoatworksToday

Will This Entire Victron Electrical System Fit In My Little Boat?Αυγ 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!Αυγ 2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!Αυγ 2026Putting the Anona Orbis Solar Camera to Work on My Property ~ 360 Security CameraΙουλ 2026

Από BoatworksToday — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.