BoatworksToday · vídeo

O que este vídeo aborda

Repairing fiberglass hull damage from only one side requires a significantly wider taper than a standard two-sided repair to ensure structural integrity. When access to the interior is blocked by molded liners or foam, grind the damaged area back to a clean edge and create a taper ratio of 18:1 or 24:1, rather than the conventional 12:1. For a hull approximately 1/8-inch thick, extend the taper at least four inches beyond the damage perimeter.7:38 Use 1708 biaxial fabric for structural strength and 1.5-ounce chop strand mat for surface stabilization and cosmetic finishing.8:12 Laminating polyester resin allows for subsequent layers of polyester-based fairing compound or gel coat to bond without additional sanding, provided the resin remains in its tacky state.14:14 After laying the glass, fill low spots with a fiber-reinforced structural putty, then apply a wax-additive gel coat or PVA to ensure a full cure.14:08 Final fairing requires sanding the perimeter first to blend the edges before addressing the center.17:46

Mais de BoatworksToday

Will This Entire Victron Electrical System Fit In My Little Boat?ago. de 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!ago. de 2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!ago. de 2026Putting the Anona Orbis Solar Camera to Work on My Property ~ 360 Security Camerajul. de 2026

De BoatworksToday — veja o barco, a tripulação e cada vídeo analisado do canal.

The Sailing Directory Newsletter

Um e-mail com os melhores achados da frota — os momentos, barcos e histórias que valem o seu tempo de visualização. Insira seu endereço para receber sua própria cópia.