BoatHowTo · βίντεο

Τι καλύπτει αυτό το βίντεο

A pontoon boat with one bilge pump in each pontoon uses a single manual switch to operate both pumps simultaneously.0:23 Nigel Calder explains the builder likely wired them this way to save money on a second switch.Watch The arrangement is acceptable because centrifugal bilge pumps can run dry without burning out, so running both when only one pontoon has water causes no damage.0:49 The manual switch is adequate for basic operation but inadequate for testing: it confirms the pumps spin but cannot verify the float switches.0:49 Each float switch has wiring routed through its hinge, and water intrusion there causes stray current corrosion that destroys the positive terminal inside the switch, disabling automatic operation.1:10 Calder notes boats have sunk because owners assumed the manual test confirmed full system function when the float switches had already failed.1:55 Proper testing requires physically lifting each float switch, or flooding the bilge if the switch is inaccessible, to confirm automatic activation.1:50 Separate switches per pump are not required, but float switch inspection is.

Περισσότερα από το BoatHowTo

How to keep you TANK CLEAN in the days of BIODIESEL.. | Ask The Expert with NIGEL CALDERΑυγ 2026PARALLELING Conductors for AMPACITY - is that SAFE?? | Ask The Expert with NIGEL CALDERΑυγ 2026ENGINE OIL turns BLACK right after Oil Change?? | Ask The Expert with NIGEL CALDERΑυγ 2026Same LAYUP RECOMMENDATIONS for FAME and HVO bio diesel? | Ask The Expert with NIGEL CALDERΑυγ 2026

Από BoatHowTo — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.