BoatworksToday · βίντεο

Τι καλύπτει αυτό το βίντεο

Andy fabricates a custom fiberglass mold to create a watertight lip for the aft deck of a Bertram 25.15:03 The project aims to seal the transom area, preventing water ingress while accommodating future seating and storage.0:51 To achieve the necessary profile, he constructs a form and tests clear packing tape as a release agent against polyester resin, confirming it resists melting from the styrene.15:50 He chooses chopped strand mat (CSM) over 1708 biaxial fabric for its ability to conform to tight, intricate curves.16:31 He demonstrates a technique for tearing CSM rather than cutting it, which creates wispy, overlapping edges that lock together for better structural integration on complex shapes.18:59 He mixes eight-ounce batches of polyester laminating resin catalyzed at one percent with MEK, noting that the thickness of the three-to-five-layer layup will generate sufficient heat to ensure a proper cure.21:03 He also advises warming two-part epoxy cartridges like Thixo in a heating blanket to reduce viscosity and priming the nozzle before application to ensure a correct mix ratio.12:50

Περισσότερα από το BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!Οκτ 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!Σεπ 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)Σεπ 2026Will This Entire Victron Electrical System Fit In My Little Boat?Αυγ 2026

Από BoatworksToday — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.