BoatworksToday · video

Cosa tratta questo video

Andy fabricates a custom fiberglass mold to create a watertight lip for the aft deck of a Bertram 25.15:03 The project aims to seal the transom area, preventing water ingress while accommodating future seating and storage.0:51 To achieve the necessary profile, he constructs a form and tests clear packing tape as a release agent against polyester resin, confirming it resists melting from the styrene.15:50 He chooses chopped strand mat (CSM) over 1708 biaxial fabric for its ability to conform to tight, intricate curves.16:31 He demonstrates a technique for tearing CSM rather than cutting it, which creates wispy, overlapping edges that lock together for better structural integration on complex shapes.18:59 He mixes eight-ounce batches of polyester laminating resin catalyzed at one percent with MEK, noting that the thickness of the three-to-five-layer layup will generate sufficient heat to ensure a proper cure.21:03 He also advises warming two-part epoxy cartridges like Thixo in a heating blanket to reduce viscosity and priming the nozzle before application to ensure a correct mix ratio.12:50

Altro da BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!ott 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!set 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)set 2026Will This Entire Victron Electrical System Fit In My Little Boat?ago 2026

Da BoatworksToday — guarda la barca, l'equipaggio e ogni video analizzato del canale.

The Sailing Directory Newsletter

Una email con le migliori scoperte della flotta — i momenti, le barche e le storie che meritano il tuo tempo di visione. Inserisci il tuo indirizzo per riceverne una copia.