BoatworksToday · vídeo

O que este vídeo aborda

Andy fabricates a custom fiberglass mold to create a watertight lip for the aft deck of a Bertram 25.15:03 The project aims to seal the transom area, preventing water ingress while accommodating future seating and storage.0:51 To achieve the necessary profile, he constructs a form and tests clear packing tape as a release agent against polyester resin, confirming it resists melting from the styrene.15:50 He chooses chopped strand mat (CSM) over 1708 biaxial fabric for its ability to conform to tight, intricate curves.16:31 He demonstrates a technique for tearing CSM rather than cutting it, which creates wispy, overlapping edges that lock together for better structural integration on complex shapes.18:59 He mixes eight-ounce batches of polyester laminating resin catalyzed at one percent with MEK, noting that the thickness of the three-to-five-layer layup will generate sufficient heat to ensure a proper cure.21:03 He also advises warming two-part epoxy cartridges like Thixo in a heating blanket to reduce viscosity and priming the nozzle before application to ensure a correct mix ratio.12:50

Mais de BoatworksToday

Will This Entire Victron Electrical System Fit In My Little Boat?08/2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!08/2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!08/2026Putting the Anona Orbis Solar Camera to Work on My Property ~ 360 Security Camera07/2026

De BoatworksToday — veja o barco, a tripulação e todos os vídeos analisados do canal.

The Sailing Directory Newsletter

Um email com os melhores achados da frota — os momentos, barcos e histórias que valem o seu tempo de visualização. Insira o seu endereço para receber a sua cópia.