BoatworksToday · vidéo

Ce que couvre cette vidéo

Andy fabricates a custom fiberglass mold to create a watertight lip for the aft deck of a Bertram 25.15:03 The project aims to seal the transom area, preventing water ingress while accommodating future seating and storage.0:51 To achieve the necessary profile, he constructs a form and tests clear packing tape as a release agent against polyester resin, confirming it resists melting from the styrene.15:50 He chooses chopped strand mat (CSM) over 1708 biaxial fabric for its ability to conform to tight, intricate curves.16:31 He demonstrates a technique for tearing CSM rather than cutting it, which creates wispy, overlapping edges that lock together for better structural integration on complex shapes.18:59 He mixes eight-ounce batches of polyester laminating resin catalyzed at one percent with MEK, noting that the thickness of the three-to-five-layer layup will generate sufficient heat to ensure a proper cure.21:03 He also advises warming two-part epoxy cartridges like Thixo in a heating blanket to reduce viscosity and priming the nozzle before application to ensure a correct mix ratio.12:50

Plus de vidéos de BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!oct. 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!sept. 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)sept. 2026Will This Entire Victron Electrical System Fit In My Little Boat?août 2026

De BoatworksToday — voir le bateau, l'équipage et chaque vidéo analysée de la chaîne.

The Sailing Directory Newsletter

Un e-mail avec les meilleures trouvailles de la flotte — les moments, les bateaux et les histoires qui valent la peine d'être regardés. Entrez votre adresse pour recevoir votre propre exemplaire.