Sven Yrvind · βίντεο

Τι καλύπτει αυτό το βίντεο

Sven Yrvind fits and scarfs Divinycell foam panels to form the hull sides of his small boat build.0:02 Working with four sheets total, he cuts pieces to fill gaps between sections — one top piece measures 40 mm, a lower section 55 mm — and scarfs them butt-to-butt directly in place rather than pre-joining them on a bench.0:16 He notes this in-place scarfing is a key advantage of foam-core construction over plywood: offcuts can be glued together to fill gaps, producing very little waste.0:41 After cutting two more pieces for the bow section, he dry-fits them on both sides to confirm the hull is symmetrical, using a centerline string stretched along the bottom as the reference datum rather than the support frames.2:02 A small radius will be added at the sheer by gluing a roughly 3 cm strip on the inside face.1:27 The session ends with all four sheets accounted for and the hull-side panels fitting cleanly to the centerline string.3:27

Περισσότερα από το Sven Yrvind

Nervously Cutting the Divinycell Sheets.Οκτ 2026Trying to Get the Sheerline Right.Οκτ 2026More molds up.Οκτ 2026The First Molds Are Up.Οκτ 2026

Από Sven Yrvind — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.