BoatworksToday · βίντεο

Τι καλύπτει αυτό το βίντεο

Fairing a transom requires a systematic approach to identify and level high and low spots before painting. Applying a guide coat of primer reveals surface imperfections, such as pinholes and uneven areas, by highlighting where sanding blocks make contact.3:39 For rough fairing, an electric longboard reduces physical strain, while a rigid 32-to-34-inch manual sanding board ensures a flat finish for fine-tuning.5:53 When applying filler, pulling the trowel lengthwise across the surface—rather than across the contour—prevents the tool from following dips and ensures the filler bridges gaps.11:29 If the primer remains within its 24-hour recoat window, spot-filling pinholes with epoxy filler requires no intermediate sanding.18:27 After filling, sanding with 120-grit paper followed by three consecutive daily coats of primer creates a smooth, paint-ready surface.24:25 A dry fit of hardware, such as an outboard bracket, confirms that the transom surface is sufficiently flat before final assembly.21:43

Περισσότερα από το BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!Οκτ 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!Σεπ 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)Σεπ 2026Will This Entire Victron Electrical System Fit In My Little Boat?Αυγ 2026

Από BoatworksToday — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.