BoatworksToday · video

Hva denne videoen dekker

Fairing a transom requires a systematic approach to identify and level high and low spots before painting. Applying a guide coat of primer reveals surface imperfections, such as pinholes and uneven areas, by highlighting where sanding blocks make contact.3:39 For rough fairing, an electric longboard reduces physical strain, while a rigid 32-to-34-inch manual sanding board ensures a flat finish for fine-tuning.5:53 When applying filler, pulling the trowel lengthwise across the surface—rather than across the contour—prevents the tool from following dips and ensures the filler bridges gaps.11:29 If the primer remains within its 24-hour recoat window, spot-filling pinholes with epoxy filler requires no intermediate sanding.18:27 After filling, sanding with 120-grit paper followed by three consecutive daily coats of primer creates a smooth, paint-ready surface.24:25 A dry fit of hardware, such as an outboard bracket, confirms that the transom surface is sufficiently flat before final assembly.21:43

Mer fra BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!okt. 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!sep. 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)sep. 2026Will This Entire Victron Electrical System Fit In My Little Boat?aug. 2026

Fra BoatworksToday – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.