BoatworksToday · vídeo

Qué cubre este vídeo

Fiberglassing stringer extensions to the transom of a Bertram 25 requires a strategic approach to material layering and surface preparation. To ensure a chemical bond without sanding, use a non-waxed, polyester-based structural repair putty as a base.5:09 When laminating 1708 biaxial fiberglass over complex angles, cut the fabric into progressively larger pieces to achieve a flush transition.6:13 To manage tight radii and wrap the glass around the transom, cut relief slits into the fabric to allow the material to fan out and maintain surface contact.7:01 Apply a fillet of structural putty to create a smooth transition ramp before laying the wet fiberglass.12:36 Work wet-on-wet to allow for manual contouring and shaping of the laminate before the resin cures.13:17 Leaving the bottom edges open ensures potential drainage.8:00 Proper planning and dry-fitting the fiberglass pieces before catalyzing the resin prevents errors during the fast-paced layup process.7:36

Más de BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!oct 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!sept 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)sept 2026Will This Entire Victron Electrical System Fit In My Little Boat?ago 2026

De BoatworksToday — mira el barco del canal, la tripulación y cada vídeo analizado.

The Sailing Directory Newsletter

Un correo electrónico con los mejores hallazgos de la flota: los momentos, barcos e historias que merecen tu tiempo de visionado. Introduce tu dirección para recibir tu propia copia.