BoatworksToday · vídeo

O que este vídeo aborda

Fiberglassing stringer extensions to the transom of a Bertram 25 requires a strategic approach to material layering and surface preparation. To ensure a chemical bond without sanding, use a non-waxed, polyester-based structural repair putty as a base.5:09 When laminating 1708 biaxial fiberglass over complex angles, cut the fabric into progressively larger pieces to achieve a flush transition.6:13 To manage tight radii and wrap the glass around the transom, cut relief slits into the fabric to allow the material to fan out and maintain surface contact.7:01 Apply a fillet of structural putty to create a smooth transition ramp before laying the wet fiberglass.12:36 Work wet-on-wet to allow for manual contouring and shaping of the laminate before the resin cures.13:17 Leaving the bottom edges open ensures potential drainage.8:00 Proper planning and dry-fitting the fiberglass pieces before catalyzing the resin prevents errors during the fast-paced layup process.7:36

Mais de BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!10/2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!09/2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)09/2026Will This Entire Victron Electrical System Fit In My Little Boat?08/2026

De BoatworksToday — veja o barco, a tripulação e todos os vídeos analisados do canal.

The Sailing Directory Newsletter

Um email com os melhores achados da frota — os momentos, barcos e histórias que valem o seu tempo de visualização. Insira o seu endereço para receber a sua cópia.