BoatHowTo · vídeo

Qué cubre este vídeo

Load testing a house battery bank with a digital load tester — even a $1,300 meter — cannot accurately measure capacity loss in deep-cycle AGM batteries, according to Nigel Calder.▶ 0:14 The only reliable method is a full discharge cycle: fully recharge the bank, discharge it completely, measure the amp-hours out, and compare that figure to the rated capacity.▶ 0:55 Calder acknowledges this is harmful to batteries and should not be done routinely, but it is the only accurate diagnostic when a bank appears to be losing capacity.▶ 1:12 If sulfation is the cause of capacity loss, recovery is possible for flooded and standard AGM batteries — not gel cells.▶ 1:26 AGM batteries with carbon foam negative plates are specifically noted as confusing even high-end load testers.▶ 0:42 The discussion also references a Boat Electrics 101 course covering both capacity testing procedures and sulfated-battery recovery techniques.▶ 1:46

Más de BoatHowTo

ONE SWITCH for TWO PUMPS?? (Pontoon Boat Setup) | Ask The Expert with NIGEL CALDERjul 2026OIL LEAKS at the Crankshaft... | Ask The Expert with NIGEL CALDERjul 20261-2-both switch - Cost effective charging system on small boats? 🤔 Ask The Expert with NIGEL CALDERjun 202648V or 24V - What makes more sense on a Boat? | Ask The Expert with NIGEL CALDERjun 2026

De BoatHowTo — mira el barco del canal, la tripulación y cada vídeo analizado.