BoatHowTo · vidéo

Ce que couvre cette vidéo

Jan Attenstedt and Nigel Calder explain that a standard multimeter provides unreliable battery health data because voltage readings fluctuate based on recent charge or discharge currents.Watch To accurately test battery capacity, a user must fully charge the battery and then apply a constant load while tracking amp-hours via a battery monitoring system.1:09 A true capacity test requires discharging a 12-volt battery down to 10.5 volts, though this process causes minor internal damage and should be performed sparingly.1:26 During this discharge, voltage drops slowly until it reaches approximately 11 volts, at which point the decline accelerates rapidly, necessitating close monitoring to prevent over-discharge.3:13 Alternatively, users can monitor for sulfation by observing if a battery charges faster than usual or delivers fewer amp-hours than its nominal rating.2:14 Comparing resting voltage against published state-of-charge charts after a partial discharge offers a rough estimate of health, though this method remains imprecise.1:55 Quality AGM or gel cell batteries should last eight to ten years under proper duty cycles.3:47

Plus de vidéos de BoatHowTo

How to keep you TANK CLEAN in the days of BIODIESEL.. | Ask The Expert with NIGEL CALDERaoût 2026PARALLELING Conductors for AMPACITY - is that SAFE?? | Ask The Expert with NIGEL CALDERaoût 2026ENGINE OIL turns BLACK right after Oil Change?? | Ask The Expert with NIGEL CALDERaoût 2026Same LAYUP RECOMMENDATIONS for FAME and HVO bio diesel? | Ask The Expert with NIGEL CALDERaoût 2026

De BoatHowTo — voir le bateau, l'équipage et chaque vidéo analysée de la chaîne.

The Sailing Directory Newsletter

Un e-mail avec les meilleures trouvailles de la flotte — les moments, les bateaux et les histoires qui valent la peine d'être regardés. Entrez votre adresse pour recevoir votre propre exemplaire.