Sven Yrvindvidéo
Cheap line tensioner for my inside steering.
12 août 2026 · 3 min · 2K vues
Ce que couvre cette vidéo
Sven Yrvind demonstrates a low-cost line tensioner built for inside steering on a small boat.0:17 The device uses a weighted line tensioned by a sweat-and-tail method against a camcleat, a knob, and a hole that keeps the line positioned correctly when pulled sideways.1:11 The capstan equation governs the design: friction over an angle in radians reduces the input force to one-tenth, so a 150-kilogram working-load component can hold 1.5 tonnes.0:48 Pulling the line sideways across the knot multiplies force by a further factor of three, achieved by offsetting the attachment point 2 centimeters over a 6-centimeter span.1:57 The arrangement replaces four rope clutches — two per side — that would otherwise be needed for the steering system.2:54 Yrvind notes the solution is primarily intended for his next boat, where eliminating rope clutches reduces cost significantly.2:33 The capstan equation's mechanical advantage makes a simple, cheap fitting adequate where an expensive clutch would otherwise be required.
Plus de vidéos de Sven Yrvind
De Sven Yrvind — voir le bateau, l'équipage et chaque vidéo analysée de la chaîne.
The Sailing Directory Newsletter
Un e-mail avec les meilleures trouvailles de la flotte — les moments, les bateaux et les histoires qui valent la peine d'être regardés. Entrez votre adresse pour recevoir votre propre exemplaire.