BoatHowTo · video

Cosa tratta questo video

Nigel Calder explains that turbocharger cooldown before engine shutdown matters far more than warmup.▶ 1:29 If an engine is shut down immediately after running at wide-open throttle, the turbo continues spinning while red-hot with no fresh oil reaching the bearings; the residual oil carbonizes and destroys the bearings.▶ 0:50 In a typical boating context, slow-speed maneuvering into a slip or while pulling anchor provides the cooldown naturally, so no deliberate idle period is usually needed.▶ 1:19 Warmup is similarly a non-issue: by the time a boat clears the dock or retrieves the anchor, the engine is warm enough to go to full throttle.▶ 1:39 Calder also recommends periodically running the engine at high speed and load to prevent carbon buildup and to exercise the turbo's wastegate — a bypass valve that opens only above a certain RPM threshold and can seize if never actuated, causing further problems.▶ 2:04 The practical rule: normal marina maneuvering handles cooldown automatically, but skippers who never push their engines risk a stuck wastegate.

Altro da BoatHowTo

ONE SWITCH for TWO PUMPS?? (Pontoon Boat Setup) | Ask The Expert with NIGEL CALDERlug 2026OIL LEAKS at the Crankshaft... | Ask The Expert with NIGEL CALDERlug 20261-2-both switch - Cost effective charging system on small boats? 🤔 Ask The Expert with NIGEL CALDERgiu 202648V or 24V - What makes more sense on a Boat? | Ask The Expert with NIGEL CALDERgiu 2026

Da BoatHowTo — guarda la barca, l'equipaggio e ogni video analizzato del canale.