BoatworksToday · video

Hva denne videoen dekker

Andy replaces structural bulkheads by first creating templates from OSB before cutting the final panels from Coosa board.▶ 3:05 To ensure a precise fit without creating hard spots against the hull, he cuts the templates with a slight gap, aiming for a fit that slides into position without requiring force.▶ 3:53 He uses a laser level to ensure the new bulkheads are plumb and square, which simplifies the future installation of a door frame.▶ 16:01 When transferring the template shapes to the expensive Coosa panels, he aligns the straight edges with the factory edge of the material to maintain structural integrity and minimize waste.▶ 13:34 He notes that while the bulkheads should touch the hull for support, they must not be wedged in, as forced contact creates localized stress points.▶ 4:12 The process involves iterative trimming and fitting until the panels achieve a tolerance within 1/16th of an inch.▶ 16:29

Mer fra BoatworksToday

I Wasn't Sure This Would Work | 42 Hour BBQ on Solar Power | Jackery HomePower 3600 Plus!juli 2026Keel Faired, Barrier Coat Applied ~ Last Hurdle Before Building the Interior Of This Sailboat!juni 2026Everything Fits! ~ Coosa Bulkheads, New Soles & Closing Out The Old Thruhulls!juni 2026Giraffe Tools x Boatworks | Bringing a 56-Year-Old Sailboat Back To Life!mai 2026

Fra BoatworksToday – se kanalens båt, mannskap og alle analyserte videoer.