BoatworksToday · vídeo

Qué cubre este vídeo

Andy replaces structural bulkheads by first creating templates from OSB before cutting the final panels from Coosa board.3:05 To ensure a precise fit without creating hard spots against the hull, he cuts the templates with a slight gap, aiming for a fit that slides into position without requiring force.3:53 He uses a laser level to ensure the new bulkheads are plumb and square, which simplifies the future installation of a door frame.16:01 When transferring the template shapes to the expensive Coosa panels, he aligns the straight edges with the factory edge of the material to maintain structural integrity and minimize waste.13:34 He notes that while the bulkheads should touch the hull for support, they must not be wedged in, as forced contact creates localized stress points.4:12 The process involves iterative trimming and fitting until the panels achieve a tolerance within 1/16th of an inch.16:29

Más de BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!oct 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!sept 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)sept 2026Will This Entire Victron Electrical System Fit In My Little Boat?ago 2026

De BoatworksToday — mira el barco del canal, la tripulación y cada vídeo analizado.

The Sailing Directory Newsletter

Un correo electrónico con los mejores hallazgos de la flota: los momentos, barcos e historias que merecen tu tiempo de visionado. Introduce tu dirección para recibir tu propia copia.