BoatworksToday · video

Cosa tratta questo video

Andy replaces structural bulkheads by first creating templates from OSB before cutting the final panels from Coosa board.3:05 To ensure a precise fit without creating hard spots against the hull, he cuts the templates with a slight gap, aiming for a fit that slides into position without requiring force.3:53 He uses a laser level to ensure the new bulkheads are plumb and square, which simplifies the future installation of a door frame.16:01 When transferring the template shapes to the expensive Coosa panels, he aligns the straight edges with the factory edge of the material to maintain structural integrity and minimize waste.13:34 He notes that while the bulkheads should touch the hull for support, they must not be wedged in, as forced contact creates localized stress points.4:12 The process involves iterative trimming and fitting until the panels achieve a tolerance within 1/16th of an inch.16:29

Altro da BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!ott 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!set 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)set 2026Will This Entire Victron Electrical System Fit In My Little Boat?ago 2026

Da BoatworksToday — guarda la barca, l'equipaggio e ogni video analizzato del canale.

The Sailing Directory Newsletter

Una email con le migliori scoperte della flotta — i momenti, le barche e le storie che meritano il tuo tempo di visione. Inserisci il tuo indirizzo per riceverne una copia.