BoatworksToday · vidéo

Ce que couvre cette vidéo

Andy replaces structural bulkheads by first creating templates from OSB before cutting the final panels from Coosa board.3:05 To ensure a precise fit without creating hard spots against the hull, he cuts the templates with a slight gap, aiming for a fit that slides into position without requiring force.3:53 He uses a laser level to ensure the new bulkheads are plumb and square, which simplifies the future installation of a door frame.16:01 When transferring the template shapes to the expensive Coosa panels, he aligns the straight edges with the factory edge of the material to maintain structural integrity and minimize waste.13:34 He notes that while the bulkheads should touch the hull for support, they must not be wedged in, as forced contact creates localized stress points.4:12 The process involves iterative trimming and fitting until the panels achieve a tolerance within 1/16th of an inch.16:29

Plus de vidéos de BoatworksToday

Why Is My 920Ah Sailboat Battery Bank So Big FOR THIS TINY SAILBOAT?? This Is Why ;-)!oct. 2026New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!sept. 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)sept. 2026Will This Entire Victron Electrical System Fit In My Little Boat?août 2026

De BoatworksToday — voir le bateau, l'équipage et chaque vidéo analysée de la chaîne.

The Sailing Directory Newsletter

Un e-mail avec les meilleures trouvailles de la flotte — les moments, les bateaux et les histoires qui valent la peine d'être regardés. Entrez votre adresse pour recevoir votre propre exemplaire.