BoatworksToday · video

Hva denne videoen dekker

Preparing a boat transom for a new Coosa board core requires extensive surface leveling and structural modification. To ensure a flush fit for the two-inch thick Coosa laminate, the transom trough must be ground down to remove existing lips and previous owner modifications. Side stringer pockets require cutting and grinding to allow the core to drop into place. To prevent thickened epoxy from leaking into the Armstrong bracket’s internal flotation chamber during installation, each of the 25 mounting holes is dished out by approximately two millimeters. A single layer of fiberglass cloth is then applied over each hole using laminating polyester resin. Once cured, these patches are sealed with wax-added gel coat and the surrounding area is faired with compound to create a level bonding surface. Keeping fairing compound thickness under a quarter-inch ensures structural integrity, with deeper voids requiring additional fiberglass buildup rather than excessive filler.

Mer fra BoatworksToday

I Was Wrong About My Boat's Victron Wiring (You Were Right!)sep. 2026Will This Entire Victron Electrical System Fit In My Little Boat?aug. 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!aug. 2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!aug. 2026

Fra BoatworksToday – se kanalens båt, mannskap og alle analyserte videoer.

The Sailing Directory Newsletter

Én e-post med flåtens beste funn – øyeblikkene, båtene og historiene som er verdt din seertid. Skriv inn din egen adresse for å få din egen kopi.