Sven Yrvind · vídeo

O que este vídeo aborda

Sven Yrvind reinforces the mast step on his small, high-latitude boat by securing it with additional screws set in epoxy.▶ 0:00 He cleans the mounting surfaces with acetone and pre-drills holes before driving the screws into the structure.▶ 0:00 To address the mast's backward lean, he plans to offset the rudder and adjust the lines for the balanced lug sail.▶ 1:06 He also modifies the mast step by winding polyester fibers saturated with epoxy around the base to increase its width and structural integrity.▶ 3:11 For the antenna installation, he drills a hole through the deck and plans to seal the cable entry with self-organizing tape to prevent water ingress.▶ 2:04 He tests the accessibility of the rigging by reaching over the deck to tie knots, confirming the configuration is manageable despite the physical constraints of the small vessel.▶ 3:42

Mais de Sven Yrvind

Kai the bow paddle.jul. de 2026About safety.jul. de 2026My solution to crossing the Doldrums without using an engine.jul. de 2026Goose Barnacles Remower.jul. de 2026

De Sven Yrvind — veja o barco, a tripulação e cada vídeo analisado do canal.