Sven Yrvind · vídeo

O que este vídeo aborda

Sven Yrvind fabricates custom hardware for the re-wing system on his small, shallow-draft boat intended for a 14,000-mile nonstop Southern Ocean voyage.▶ 0:15 He constructs long mounting screws from threaded rods, using washers as spacers to compensate for varying lengths and material thickness.▶ 0:45 To ensure a precise fit, he grinds down the wood mounting surface to accommodate the screw length.▶ 1:21 He removes the plastic coating from the aluminum extrusions, noting that the protective layer is unnecessary for his specific mast design.▶ 3:53 To secure the crank lever to the extrusion, he installs two screws per side and plugs the bottom with glass fiber.▶ 4:29 He then pours epoxy into the assembly to create a permanent, structural bond between the lever and the extrusion.▶ 4:37 Each custom-fitted screw is marked for its specific hole to maintain alignment during final assembly.▶ 2:01

Mais de Sven Yrvind

Kai the bow paddle.07/2026About safety.07/2026My solution to crossing the Doldrums without using an engine.07/2026Goose Barnacles Remower.07/2026

De Sven Yrvind — veja o barco, a tripulação e todos os vídeos analisados do canal.