Sven Yrvind · vídeo

O que este vídeo aborda

Sven Yrvind fabricates custom hardware for the re-wing system on his small, shallow-draft boat intended for a 14,000-mile nonstop Southern Ocean voyage.▶ 0:15 He constructs long mounting screws from threaded rods, using washers as spacers to compensate for varying lengths and material thickness.▶ 0:45 To ensure a precise fit, he grinds down the wood mounting surface to accommodate the screw length.▶ 1:21 He removes the plastic coating from the aluminum extrusions, noting that the protective layer is unnecessary for his specific mast design.▶ 3:53 To secure the crank lever to the extrusion, he installs two screws per side and plugs the bottom with glass fiber.▶ 4:29 He then pours epoxy into the assembly to create a permanent, structural bond between the lever and the extrusion.▶ 4:37 Each custom-fitted screw is marked for its specific hole to maintain alignment during final assembly.▶ 2:01

Mais de Sven Yrvind

Kai the bow paddle.jul. de 2026About safety.jul. de 2026My solution to crossing the Doldrums without using an engine.jul. de 2026Goose Barnacles Remower.jul. de 2026

De Sven Yrvind — veja o barco, a tripulação e cada vídeo analisado do canal.