Expedition Engineering · βίντεο

Τι καλύπτει αυτό το βίντεο

A sailor replaces a failed headsail furler while anchored in the Bahamas after the unit seized due to 20 years of salt and corrosion.7:19 To remove the seized lower extrusion from the furler, the sailor uses a heat gun, a grinder with a cut-off wheel, and a hammer to break the bond.7:48 After cleaning the components with sandpaper, the sailor shrinks the metal by placing the part in a freezer for one hour, allowing for a successful reassembly.8:59 The installation requires loosening all standing rigging to create enough slack to slide the new unit onto the forestay.3:08 Once the furler is installed, the sailor re-tunes the rig under sail in 15 knots of wind, keeping the cotter pins out until the mast is properly tensioned and straight.18:51 The sailor also uses a 3D printer and ASA CF filament to fabricate a custom locking device for the furler assembly.4:57

Περισσότερα από το Expedition Engineering

One Year Update - Custom Carbon Fiber Hardtop (26)Ιουλ 2026Our Boat Kept Getting Slower. This Was Why. (24)Ιουν 2026A Few Less PROBLEMS Than Yesterday 23Απρ 2026Time it Actually Takes : Watermaker (22)Ιαν 2026

Από Expedition Engineering — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.