BoatworksToday · βίντεο

Τι καλύπτει αυτό το βίντεο

To install a new cabin sole in a 1970 Paceship 24, the project requires creating precise templates and performing a dry fit using OSB before cutting the final Coosa panels. Because the hull tapers inward, the OSB templates are oversized by approximately half an inch to allow for later undercutting and a tight final fit.1:40 The panels are beveled at 45 degrees to sit flush against the hull and make full contact with the top of the keel.6:34 The installation uses Coosa Blue Water 20 panels for structural flooring and bulkheads, while the lighter Nautical series is reserved for non-structural components like bunks and cabinetry.8:44 When cutting Coosa, carbide-tipped blades are essential, as the fiberglass reinforcement within the panels dulls standard high-speed steel blades within minutes.10:25 Once the panels are cut and fitted, they are glassed on both sides to create a unified, stiff floor structure.

Περισσότερα από το BoatworksToday

I Was Wrong About My Boat's Victron Wiring (You Were Right!)Σεπ 2026Will This Entire Victron Electrical System Fit In My Little Boat?Αυγ 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!Αυγ 2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!Αυγ 2026

Από BoatworksToday — δείτε το σκάφος του καναλιού, το πλήρωμα και κάθε αναλυμένο βίντεο.

The Sailing Directory Newsletter

Ένα email με τις καλύτερες ανακαλύψεις του στόλου — τις στιγμές, τα σκάφη και τις ιστορίες που αξίζουν τον χρόνο παρακολούθησής σας. Εισάγετε τη διεύθυνσή σας για να λάβετε το δικό σας αντίγραφο.