BoatworksToday · vídeo

Qué cubre este vídeo

To install a new cabin sole in a 1970 Paceship 24, the project requires creating precise templates and performing a dry fit using OSB before cutting the final Coosa panels. Because the hull tapers inward, the OSB templates are oversized by approximately half an inch to allow for later undercutting and a tight final fit.1:40 The panels are beveled at 45 degrees to sit flush against the hull and make full contact with the top of the keel.6:34 The installation uses Coosa Blue Water 20 panels for structural flooring and bulkheads, while the lighter Nautical series is reserved for non-structural components like bunks and cabinetry.8:44 When cutting Coosa, carbide-tipped blades are essential, as the fiberglass reinforcement within the panels dulls standard high-speed steel blades within minutes.10:25 Once the panels are cut and fitted, they are glassed on both sides to create a unified, stiff floor structure.

Más de BoatworksToday

I Was Wrong About My Boat's Victron Wiring (You Were Right!)sept 2026Will This Entire Victron Electrical System Fit In My Little Boat?ago 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!ago 2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!ago 2026

De BoatworksToday — mira el barco del canal, la tripulación y cada vídeo analizado.

The Sailing Directory Newsletter

Un correo electrónico con los mejores hallazgos de la flota: los momentos, barcos e historias que merecen tu tiempo de visionado. Introduce tu dirección para recibir tu propia copia.