Sailing Zephyr IV · vidéo

Ce que couvre cette vidéo

Excessive play in the Whitlock Cobra steering pedestal on Zephyr IV developed a loud clank in heavy weather off St Albans Head, and the boat would randomly veer off course when sailing downwind with the wheel centered.3:09 Dave traced the fault to the worn bottom bearing inside the pedestal — a known failure point on the Whitlock Cobra design made by Lumar, where a shaft runs the full length of the pedestal and its lower bearing wears sloppy over time.3:25 Removing the pedestal required stripping the cockpit grating, steering wheel, compass, bow thruster control panel, and engine throttle and gear cables, then working alone to loosen bolts from below with mole grips while unscrewing from the cockpit above.4:18 Because replacing the bottom bearing requires cutting off the arm at the base of the shaft and welding a replacement, Dave drove roughly 20 miles along the coast to Yacht Steering Services, where Cliff machined and welded the repair on a lathe.7:55 Reinstallation used sealant around the cockpit-floor penetration to prevent water ingress into the aft cabin below.9:05 After refitting, the wheel turned with no appreciable play.11:01 The same passage also confirmed a new propeller had added close to a knot of boat speed.0:26

Bateaux dans cette vidéo

Plus de vidéos de Sailing Zephyr IV

Why Cowes Can Be A Sailor’s Nightmare (And How To Fix It)sept. 2026I Took the BLUETTI Elite 100 V2 on a boat – Here's What Happenedaoût 2026Day in the Life of a Solo Sailor at 82 : Cowes to Poolejuil. 2026Boat Toilet Not Working? I Replaced the Jabsco Pump at 82!juil. 2026

De Sailing Zephyr IV — voir le bateau, l'équipage et chaque vidéo analysée de la chaîne.

The Sailing Directory Newsletter

Un e-mail avec les meilleures trouvailles de la flotte — les moments, les bateaux et les histoires qui valent la peine d'être regardés. Entrez votre adresse pour recevoir votre propre exemplaire.