Sven Yrvind · video

Cosa tratta questo video

Sven Yrvind constructs a structural component for his boat using a full-scale mockup and NM Epoxy.▶ 0:01 He prepares the assembly by applying tape to prevent unwanted adhesion and sets the pieces into position with a height of 9.6 centimeters.▶ 0:08 After applying the epoxy, he secures the assembly with clamps to ensure a solid bond during the curing process.▶ 0:54 The project involves reinforcing a fiberglass section intended to house a switch, requiring precise measurements to accommodate the component.▶ 1:34 He drills a small hole to seat a screw, using a rubber piece to center the hardware and maintain the profile during the cure.▶ 2:01 He plans to add further fiberglass reinforcement to the exterior once the initial internal layer dries.▶ 1:34 The process demonstrates the use of epoxy and fiberglass to create custom mounting points for electrical hardware.

Altro da Sven Yrvind

Kai the bow paddle.lug 2026About safety.lug 2026My solution to crossing the Doldrums without using an engine.lug 2026Goose Barnacles Remower.lug 2026

Da Sven Yrvind — guarda la barca, l'equipaggio e ogni video analizzato del canale.