Sven Yrvind · vídeo

O que este vídeo aborda

Sven Yrvind constructs a structural component for his boat using a full-scale mockup and NM Epoxy.▶ 0:01 He prepares the assembly by applying tape to prevent unwanted adhesion and sets the pieces into position with a height of 9.6 centimeters.▶ 0:08 After applying the epoxy, he secures the assembly with clamps to ensure a solid bond during the curing process.▶ 0:54 The project involves reinforcing a fiberglass section intended to house a switch, requiring precise measurements to accommodate the component.▶ 1:34 He drills a small hole to seat a screw, using a rubber piece to center the hardware and maintain the profile during the cure.▶ 2:01 He plans to add further fiberglass reinforcement to the exterior once the initial internal layer dries.▶ 1:34 The process demonstrates the use of epoxy and fiberglass to create custom mounting points for electrical hardware.

Mais de Sven Yrvind

Kai the bow paddle.07/2026About safety.07/2026My solution to crossing the Doldrums without using an engine.07/2026Goose Barnacles Remower.07/2026

De Sven Yrvind — veja o barco, a tripulação e todos os vídeos analisados do canal.