Sven Yrvind · vidéo

Ce que couvre cette vidéo

Sven Yrvind constructs a structural component for his boat using a full-scale mockup and NM Epoxy.▶ 0:01 He prepares the assembly by applying tape to prevent unwanted adhesion and sets the pieces into position with a height of 9.6 centimeters.▶ 0:08 After applying the epoxy, he secures the assembly with clamps to ensure a solid bond during the curing process.▶ 0:54 The project involves reinforcing a fiberglass section intended to house a switch, requiring precise measurements to accommodate the component.▶ 1:34 He drills a small hole to seat a screw, using a rubber piece to center the hardware and maintain the profile during the cure.▶ 2:01 He plans to add further fiberglass reinforcement to the exterior once the initial internal layer dries.▶ 1:34 The process demonstrates the use of epoxy and fiberglass to create custom mounting points for electrical hardware.

Plus de vidéos de Sven Yrvind

Kai the bow paddle.juil. 2026About safety.juil. 2026My solution to crossing the Doldrums without using an engine.juil. 2026Goose Barnacles Remower.juil. 2026

De Sven Yrvind — voir le bateau, l'équipage et chaque vidéo analysée de la chaîne.