BoatworksToday · video

Cosa tratta questo video

Andy fits custom fiberglass framework into the transom area of a Bertram 25 to create drainage and support for a future hatch cover.2:28 He uses a belt sander to taper the bottom edges of the fiberglass components, ensuring they sit flush within the existing deck pockets.4:07 To reinforce the underside of these pockets and seal gaps, he applies small, frayed pieces of chopped strand mat saturated in epoxy, effectively paper-mashing the material to provide structural support.7:22 After allowing the epoxy to cure overnight, he trims the excess glass and prepares the remaining components for final installation.11:38 The project remains incomplete due to a power outage at the shop, which prevents further glassing and fairing work until the following week.18:15

Altro da BoatworksToday

I Was Wrong About My Boat's Victron Wiring (You Were Right!)set 2026Will This Entire Victron Electrical System Fit In My Little Boat?ago 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!ago 2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!ago 2026

Da BoatworksToday — guarda la barca, l'equipaggio e ogni video analizzato del canale.

The Sailing Directory Newsletter

Una email con le migliori scoperte della flotta — i momenti, le barche e le storie che meritano il tuo tempo di visione. Inserisci il tuo indirizzo per riceverne una copia.