BoatworksToday · vidéo

Ce que couvre cette vidéo

Andy fits custom fiberglass framework into the transom area of a Bertram 25 to create drainage and support for a future hatch cover.2:28 He uses a belt sander to taper the bottom edges of the fiberglass components, ensuring they sit flush within the existing deck pockets.4:07 To reinforce the underside of these pockets and seal gaps, he applies small, frayed pieces of chopped strand mat saturated in epoxy, effectively paper-mashing the material to provide structural support.7:22 After allowing the epoxy to cure overnight, he trims the excess glass and prepares the remaining components for final installation.11:38 The project remains incomplete due to a power outage at the shop, which prevents further glassing and fairing work until the following week.18:15

Plus de vidéos de BoatworksToday

I Was Wrong About My Boat's Victron Wiring (You Were Right!)sept. 2026Will This Entire Victron Electrical System Fit In My Little Boat?août 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!août 2026V-Berth Electrical Layout On A Small Sailboat: It's Tight, But It Should Work!août 2026

De BoatworksToday — voir le bateau, l'équipage et chaque vidéo analysée de la chaîne.

The Sailing Directory Newsletter

Un e-mail avec les meilleures trouvailles de la flotte — les moments, les bateaux et les histoires qui valent la peine d'être regardés. Entrez votre adresse pour recevoir votre propre exemplaire.