BoatworksToday · video

What this video covers

Andy fits custom fiberglass framework into the transom area of a Bertram 25 to create drainage and support for a future hatch cover.2:28 He uses a belt sander to taper the bottom edges of the fiberglass components, ensuring they sit flush within the existing deck pockets.4:07 To reinforce the underside of these pockets and seal gaps, he applies small, frayed pieces of chopped strand mat saturated in epoxy, effectively paper-mashing the material to provide structural support.7:22 After allowing the epoxy to cure overnight, he trims the excess glass and prepares the remaining components for final installation.11:38 The project remains incomplete due to a power outage at the shop, which prevents further glassing and fairing work until the following week.18:15

More from BoatworksToday

New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!Sept 2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)Sept 2026Will This Entire Victron Electrical System Fit In My Little Boat?Aug 2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!Aug 2026

From BoatworksToday — see the channel’s boat, crew, and every analysed video.

The Sailing Directory Newsletter

One email with the fleet's best finds — the moments, boats, and stories worth your watch time. Enter your own address to get your own copy.