BoatworksToday · vídeo

O que este vídeo aborda

Andy fits custom fiberglass framework into the transom area of a Bertram 25 to create drainage and support for a future hatch cover.2:28 He uses a belt sander to taper the bottom edges of the fiberglass components, ensuring they sit flush within the existing deck pockets.4:07 To reinforce the underside of these pockets and seal gaps, he applies small, frayed pieces of chopped strand mat saturated in epoxy, effectively paper-mashing the material to provide structural support.7:22 After allowing the epoxy to cure overnight, he trims the excess glass and prepares the remaining components for final installation.11:38 The project remains incomplete due to a power outage at the shop, which prevents further glassing and fairing work until the following week.18:15

Mais de BoatworksToday

New Epoch Batteries Just Landed for My Victron System But It's On Hold For Annapolis Boat Show Prep!09/2026I Was Wrong About My Boat's Victron Wiring (You Were Right!)09/2026Will This Entire Victron Electrical System Fit In My Little Boat?08/2026The Primer Mistake You're Probably Making Painting Your Boat: Film Thickness, Not Smoothness!08/2026

De BoatworksToday — veja o barco, a tripulação e todos os vídeos analisados do canal.

The Sailing Directory Newsletter

Um email com os melhores achados da frota — os momentos, barcos e histórias que valem o seu tempo de visualização. Insira o seu endereço para receber a sua cópia.