Sailing Jibsea · vídeo

O que este vídeo aborda

Travis installs a hot water heater on the Yanmar 4JH2E engine of Jibsea to provide hot water while motoring.1:05 He removes existing hoses connected to a hydronic system and reroutes the coolant lines to the new heater using brass elbows and new hose.2:00 To ensure proper circulation, he follows the engine schematic for inlet and outlet ports and relocates the expansion tank to a position no more than four inches below the top of the heat exchanger.7:06 After plumbing the system, he fills the loop with Yanmar coolant, manually burping the lines to remove air pockets by cycling the engine on and off.9:22 He addresses a minor leak at a fitting by applying high-temperature thread sealant.10:58 The engine runs for 30 minutes without overheating, confirming the installation is successful.11:47

Mais de Sailing Jibsea

Not so typical conditions cruising the Norwegian Sea from “A to B” - Ep 288out. de 2026Reality of YouTubing + Sailing + Adventuring | Behind the Scenes - Ep 287set. de 2026Our Backyard Is Norway’s Most Iconic Fjord - Ep 286set. de 2026The Unpredictable Dangers of Sailing Norway's Fjords - Ep 285set. de 2026

De Sailing Jibsea — veja o barco, a tripulação e cada vídeo analisado do canal.

The Sailing Directory Newsletter

Um e-mail com os melhores achados da frota — os momentos, barcos e histórias que valem o seu tempo de visualização. Insira seu endereço para receber sua própria cópia.