Sven Yrvind · vídeo

O que este vídeo aborda

Sven Yrvind fabricates and installs wooden pegs for a boat project during the Swedish winter. He uses 23-millimeter wooden stock and a 22-millimeter drill bit, refining the fit by turning the pegs on a lathe until they slide smoothly into the drilled holes.▶ 1:48 To secure the joints, he applies epoxy and uses sandpaper to ensure a precise fit.▶ 2:45 During the drilling process, he encounters a bronze screw embedded in the material, which leaves visible copper traces at the bottom of the hole.▶ 4:38 When installing the pegs, trapped air in the tight-fitting joints causes them to push back out, requiring repeated tapping until the air escapes and the seam stabilizes.▶ 5:41 The work takes place in a workshop environment while snow accumulates outside.

Mais de Sven Yrvind

Kai the bow paddle.07/2026About safety.07/2026My solution to crossing the Doldrums without using an engine.07/2026Goose Barnacles Remower.07/2026

De Sven Yrvind — veja o barco, a tripulação e todos os vídeos analisados do canal.