Sven Yrvind · vídeo

O que este vídeo aborda

Sven Yrvind fabricates and installs wooden pegs for a boat project during the Swedish winter. He uses 23-millimeter wooden stock and a 22-millimeter drill bit, refining the fit by turning the pegs on a lathe until they slide smoothly into the drilled holes.▶ 1:48 To secure the joints, he applies epoxy and uses sandpaper to ensure a precise fit.▶ 2:45 During the drilling process, he encounters a bronze screw embedded in the material, which leaves visible copper traces at the bottom of the hole.▶ 4:38 When installing the pegs, trapped air in the tight-fitting joints causes them to push back out, requiring repeated tapping until the air escapes and the seam stabilizes.▶ 5:41 The work takes place in a workshop environment while snow accumulates outside.

Mais de Sven Yrvind

Kai the bow paddle.jul. de 2026About safety.jul. de 2026My solution to crossing the Doldrums without using an engine.jul. de 2026Goose Barnacles Remower.jul. de 2026

De Sven Yrvind — veja o barco, a tripulação e cada vídeo analisado do canal.