VOILIER ODINvideo
ELECTRICITY ON BOARD, CABLES, WATTS, AMPERES, VOLTS
25 June 2023 · 29 min · 11K views
What this video covers
Installing electrical systems on a boat requires careful calculation of wire gauge based on current draw and total circuit length. To determine the correct wire size, use standard conversion tables that account for both the device's wattage or amperage and the round-trip distance of the cable run.14:48 For a 3-amp shower pump, a 1.5mm² wire is sufficient for a 4-meter run, but longer distances require increasing the wire diameter to 4mm² to prevent voltage drop.17:21 When routing cables through tight spaces like a cockpit locker or inside a balcony, pulling a messenger line before removing old wiring saves significant time.1:35
To ensure reliable connections, solder spade terminals directly to wires rather than relying solely on crimping.7:54 Using different terminal orientations for positive and negative leads acts as a mechanical safeguard against polarity reversal.8:01 When installing bilge or water pumps, use junction boxes to protect connections from moisture, though factory-supplied seals often require additional silicone sealant to ensure long-term watertight integrity.22:47 Proper planning and systematic, component-by-component installation prevent wiring errors in complex electrical layouts.3:08
Boats in this video
More from VOILIER ODIN
From VOILIER ODIN — see the channel’s boat, crew, and every analysed video.
The Sailing Directory Newsletter
One email with the fleet's best finds — the moments, boats, and stories worth your watch time. Enter your own address to get your own copy.