The On Deck Channel · video

What this video covers

Installing an Arco Zeus alternator regulator requires wiring two distinct harnesses: one for the alternator and one for the battery.0:27 For isolated ground alternators, connect the positive and negative leads directly to the alternator studs, ensuring the main lug sits first on the stud.1:59 Install an inline fuse on the positive lead, sized up to 30 amps depending on wire gauge.2:18 Use a Balmar alternator protection device as a safeguard against voltage spikes if the battery management system disconnects.3:02 Connect the field wire to energize the alternator, the stator wire for RPM signaling, and the ignition wire to a reliable switched source to enable charging.3:43

For battery sensing, use a twisted pair to minimize interference and land connections as close to the battery as possible.11:19 Networking the Zeus via CAN bus requires a properly terminated NMEA 2000 or VE.CAN backbone with a 120-ohm resistor at each end.15:26 When connecting to a Victron Cerbo GX, use a VE.CAN to NMEA 2000 adapter cable, ensuring the backbone receives 12-volt power through a fused connection.19:06 On 48-volt systems, isolate the backbone power to prevent damage to 12-volt-only network devices.20:11

More from The On Deck Channel

This is My Favorite Upgrade on a Boat... | Leopard 50Oct 2026Get a Boat They Said... It Will Be Fun | New to Boat Life SeriesSept 2026First Time Sailing... Failed | New to Boat Life SeriesSept 202624 shipping containers. A lot more than rigging!Aug 2026

From The On Deck Channel — see the channel’s boat, crew, and every analysed video.

The Sailing Directory Newsletter

One email with the fleet's best finds — the moments, boats, and stories worth your watch time. Enter your own address to get your own copy.