Entre Terras e Mares · vídeo

Qué cubre este vídeo

Edgar installs the propeller shaft and constant velocity (CV) joint on his boat, completing a long-term mechanical project.▶ 3:51 He begins by inserting the shaft into the hull tunnel from the outside, ensuring the propeller and zinc anode are correctly positioned.▶ 3:51 To secure the internal shaft bearing, he fabricates a custom stainless steel support, which he cuts to shape and welds before laminating it directly into the hull structure.▶ 7:40 He uses a mixture of polyester resin, fiber powder, and Aerosil to bond the bearing flange to the hull, allowing the resin to flow through pre-drilled holes to lock the piece in place.▶ 12:52 After aligning the shaft and CV joint, he applies high-torque thread locker to the fasteners.▶ 11:06 Although the assembly is currently functional, he plans to disassemble the CV joint later to install the water seal and final cotter pins.▶ 26:15 The process confirms that precise alignment and structural lamination are essential for mounting a shaft system within a solid hull section.

Más de Entre Terras e Mares

WE FINISHED the bow cabin LAMINATE ! S1.ep182jun 2026WE DID IT, WE FINISHED PART OF THE FORMICA IN THE BOW SUITE S1.ep 181jun 2026This week the focus was on something elsejun 2026WE DID IT! WE FINISHED THE CAPTAIN'S SUITE SINK! S1.ep180may 2026

De Entre Terras e Mares — mira el barco del canal, la tripulación y cada vídeo analizado.