Erik Aanderaa · video

What this video covers

A new Code Zero sail from Rolly Tosker, fitted to Tessie for a 3,400-nautical-mile single-handed Arctic expedition to Svalbard departing June 9–10 from Haugesund, drives the boat to 5.5–6 knots in just 8–10 knots of true wind at 50 degrees apparent.▶ 0:16 The sail furls on a CELDEAN CXR25 ratchet furler, which locks in one direction to prevent accidental unfurling.▶ 1:31 Because Code Zero loads pull sharply upward, a bobstay runs from the bow to the tip of the gennaker sprit, and Erik fabricated a custom welded bracket to secure the sprit to the deck.▶ 1:19 A 2-to-1 halyard using 65-meter Dyneema line tensions the luff; Saldén supplied the terminals.▶ 2:09 The light-air performance is critical because no diesel is available on Svalbard's north coast, requiring roughly 600 miles of self-sufficient sailing.▶ 5:35 Three Raymarine Axiom 2 chartplotters replaced older units; the faster processors handle chart zooming and updates without lag, and Raymarine's Raycharts lighthouse charts load via SD card.▶ 7:04 The mast base, which had collapsed earlier, was repaired and reinforced before departure.▶ 0:05

More from Erik Aanderaa

Sailing in a GALE for 30 minutes- UNEDITED!Apr 2026I would've NEVER had sailed if I knew THIS!Apr 2026I Crossed the North Sea Using Only a CompassMar 2026Flying over the Faroe Islands. Relaxation Film.Mar 2026

From Erik Aanderaa — see the channel’s boat, crew, and every analysed video.